Skip to content

Glossary

Car Battery Glossary: Ah, CCA, AGM, EFB and Other Terms Explained

This glossary explains the terms printed on a car battery label and used on a battery quote. The three that matter most when replacing a battery are capacity in amp hours (Ah), cold cranking amps (CCA) and the technology — standard, EFB or AGM. Match or exceed the first two and never go below the third.

Ah
Capacity
CCA
Starting power
AGM / EFB
Start-stop types
12.6 V
Fully charged

On the label

Amp hours (Ah)
The battery's capacity: how much energy it stores. A 70Ah battery can in theory supply 3.5 amps for twenty hours. Cars with more electronics need more Ah.
Cold cranking amps (CCA)
The current a battery can deliver for 30 seconds at −18°C while staying above 7.2 volts. It is the standard measure of starting power; bigger engines and diesels need more.
Reserve capacity (RC)
The number of minutes a fully charged battery can run the car's essential systems if the alternator stops charging.
Group size
The battery's physical dimensions and case style. It has to match the tray and clamp in the car, or the battery cannot be secured.
DIN and JIS
The two common case standards. DIN is the European pattern and JIS the Japanese one; they differ in height, hold-down and terminal size, and are not interchangeable.
Terminals
The positive and negative posts the car's cables clamp to. Their type and which side the positive sits on must match the car, or the cables will not reach.
Voltage (12 V)
A car battery is nominally 12 volts, made of six cells of about 2.1 volts each. A fully charged battery reads about 12.6 volts at rest.

Battery types

Flooded (standard) battery
The conventional lead-acid battery, with liquid electrolyte over lead plates. Suited to cars without start-stop.
EFB (enhanced flooded battery)
A flooded battery with thicker plates and a scrim that holds the active material in place, giving roughly double the cycling endurance of a standard battery. The minimum for start-stop cars.
AGM (absorbent glass mat)
A sealed lead-acid battery in which the electrolyte is held in glass-fibre separators. It tolerates deep discharge and repeated restarts best, and is required where the car came with AGM.
Maintenance-free (SMF)
A sealed battery that does not need topping up with water during its life. Most modern car batteries are maintenance-free.
VRLA
Valve-regulated lead-acid: a sealed battery that vents only through a pressure valve. AGM batteries are VRLA batteries.
Start-stop
A system that switches the engine off when the car is stationary and restarts it when you move off. It multiplies the number of starts and needs an EFB or AGM battery.

Testing and faults

Load test
A test that draws real current from the battery and watches how the voltage holds. It is the only reliable way to tell a discharged battery from a worn-out one.
Resting voltage
The battery's voltage after the car has been switched off for about an hour. 12.6 V is full, about 12.2 V is half, and under 12.0 V is flat.
State of charge (SoC)
How full the battery is right now, as a percentage. A discharged battery can be recharged.
State of health (SoH)
How much of its original capacity the battery can still hold. A battery with poor health cannot be fixed by charging.
Alternator
The engine-driven generator that powers the car and recharges the battery while driving. On most cars it charges at roughly 13.8 to 14.4 volts.
Parasitic drain
Current drawn from the battery while the car is parked, by alarms, trackers, dashcams or a faulty component. A large drain flattens a healthy battery in days.
Sulphation
Hard lead sulphate crystals that form on the plates when a battery sits partly or fully discharged. It reduces capacity and is the main damage caused by short trips and long parking.
Deep discharge
Draining a battery far below its normal operating range, for example by leaving the lights on. Each deep discharge permanently costs a starter battery some of its life.
Electrolyte
The mixture of sulphuric acid and water inside the battery. In hot climates the water evaporates faster, which shortens battery life.

Fitting and service

Battery registration (coding)
Telling the car's computer that a new battery has been fitted, so that it charges the battery as new. Required on many BMW, Mercedes-Benz, Audi, Volkswagen, Volvo, Land Rover and Porsche models.
Battery management system (BMS)
The sensor and software that monitor the battery's charge and age and control how it is charged. It is the system a new battery is registered to.
Memory saver
A small power supply connected during a battery change so the car keeps its radio presets, clock, seat memory and engine adaptations.
Jump start
Starting a car with a flat battery from an external power source such as a jump pack. It gets the car running but does not repair a failing battery.
Jump pack
A portable battery booster used to jump start a car without a second vehicle.
Mobile battery replacement
A service in which a technician brings the battery to the car and fits it where the car is parked, instead of the car being towed to a workshop.

Questions

Frequently asked questions

What is the difference between Ah and CCA?

Ah measures how much energy the battery stores; CCA measures how much current it can deliver in one burst to start the engine. A replacement should match or exceed both figures on the original battery.

Does CCA matter in a hot country?

Yes. CCA is measured at −18°C, but it remains the standard way to compare starting power, and a higher CCA means a stronger crank at any temperature.

What does AGM stand for?

Absorbent glass mat. The electrolyte is held in glass-fibre separators instead of sloshing freely, which makes the battery sealed and much more tolerant of repeated discharge.

What is battery registration?

It is the step of telling the car that a new battery has been fitted. Without it, cars with a battery management system keep charging the new battery as if it were the old one, which shortens its life.

Last reviewed:

Stranded with a flat battery

Find out when a technician can reach you.

Call, or send your location on WhatsApp. You get current availability and an arrival estimate for where the car is, and the price before anyone sets off.

Typically 25–40 min in Dubai · confirm yours